Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - FUEL AND INJECTION SYSTEM Sensing system Level sensor - Open circuit (B.20.A.95.90 - G.30.B.50) AFX8010 E0154-05 - Fuel Level Sensor Cause: The fuel level sensor (R-01) circuit is open. Possible failure modes: 1. Sensor supply or ground wiring is open. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "FUEL LEVEL SEN" to check the voltage range. The proper voltage range is 0.5 - 4.9 volts . A. If the voltage reading is high out of range ( 4.9 - 5.2 volts ), continue with Step 2 . B.

If the voltage reading is within the proper limits, continue the troubleshooting at Step 5 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the fuel level sensor connector X184 . Use a jumper wire to short connector X184 pin 1 to chassis ground. A. If voltage drops to less than 0.5 volts , the open circuit is not in the supply side of the circuit. Continue with Step 3 . B.

If the voltage remains high, there is an open circuit in the main frame (MF) harness between connector X184 pin 1 and connector X016 pin J2-17 wire 427 yellow. Locate the open and repair. 3. Disconnect the fuel level sensor connector X184 . Use a multimeter to check for continuity between the harness end of Connector X184 pin 2 and chassis ground. A. If there is continuity, the sensor has failed. Replace the sensor. B. If there is no continuity, there is an open circuit in the main frame (MF) harness between connector X184 pin 2 and connector X016 pin J2-14 wire 467 blue, 425 blue or 465 blue. Locate the open and repair. 4.

Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9672 1 27/05/2004 B.20.A / 86