POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0393.2 MAIN RELAY DEFECT, DATA INCORRECT 0393.3 MAIN RELAY DEFECT, SHORTED TO HIGH SOURCE 0393.4 MAIN RELAY DEFECT, SHORTED TO LOW SOURCE Cause: Defective main relay (K14) -- not switching off Effect on Engine: Engine enabled -- no restriction on fuel or speed Possible failure modes: 1. Faulty relay 2. Fault in wiring harness Solution: 1. Replace relay 14. A. Remove the fault code from the engine ECU using the electronic service tool. Check the operation of the engine. If the fault reoccurs continue with step 2. 2. Check wiring between relay 14 and engine ECU. (Short to low source) A. ENSURE THE KEYSTART SWITCH IS OFF.
Remove relay 14 and disconnect the connectors from the engine ECU (A--01). Using a suitable multi-meter check for a short to ground at pin 27 of X193 . If no short to ground is indicated continue with step 3. B. If a short to ground is indicated, disconnect connector X010, if a short to ground is still indicated trace and repair the wiring between the engine ECU (A--01) and connector X010. C. Continue to trace the short to ground at the female side of connector X010. Disconnect connector X004 and check for a short to ground at X010 pin 26. If a short is indicated repair the wiring between connectors X010 and X004.
If no short is indicated here then the short to ground must be between the male side of connector X004 and holder of relay 14. 3. Check wiring between relay 14 and engine ECU. (Short to high source) A. Remove relay 14 and disconnect the connectors from the engine ECU (A--01). Using a suitable multi-meter check for a short to +12V at pins 3 and 4 of X192 . If no short to +12V is indicated continue with step 4. B. If a short to +12V is indicated, disconnect connector X010, if a short to +12V is still indicated trace and repair the wiring between the engine ECU (A--01) and connector X010. C. Continue to trace the short to +12V at the female side of connector X010.
Disconnect connector X004 and check for a short to +12V at X010 pin 28. If a short is indicated repair the wiring between connectors X010 and X004. If no short is indicated here then the short to +12V must be between the male side of connector X004 and holder of relay 14. 4. Check for good connections onto engine ECU and at connectors X004 and X010. Check main Engine ECU relay, K14, for correct operation. Remove the fault code from the ECU memory using the electronic service tool. Operate the engine, the fault may be intermittent, wiggle test the harness and operate other functions to attempt to induce fault. If fault reoccurs return to step 2.
If fault does not occur continue with vehicle operation. Wiring harness -- Electrical schematic frame 02 (A.30.A.88 -- C.20.E.02) B.20.A / 96