Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0402.2 BOOST PRESSURE SENSOR, DATA INCORRECT 0402.3 BOOST PRESSURE SENSOR, SHORTED TO HIGH SOURCE 0402.4 BOOST PRESSURE SENSOR, SHORTED TO LOW SOURCE Cause: Signal range outside threshold limits Signal not plausible or intermittent fault Effect on Engine: Engine enabled -- no restriction on fuel or speed Possible failure modes: 1. Faulty boost pressure sensor B23 2. Faulty connector X371 or wiring Solution: 1. Mechanical Fault A. Inspect the tubing between turbocharger and inlet manifold. Ensure that no leakage points exist and all connections are tight. B. If the tubing and connections are okay continue with step 2. 2.

Harness connector fault A. Inspect the harness connector X371 onto the sensor. Ensure that the connector is not damaged, the pins are correctly located in the connector body and that it is a tight fit onto the sensor. B. If the harness connector is okay continue with step 3. 3. Boost Pressure Sensor B23 Fault A. To test the sensor the voltage needs to be read between the output wire, pin 1 and the sensor ground, pin 3, of the connector. Using a suitable probe into the wire, the voltage should range from 0.9--1.1V at 450--550 erpm, to 1.0--1.3V at 2660 erpm. If there is voltage but out of range replace sensor, if Zero volts is indicated continue with step 4. B.

The resistance of the wiring within the sensor can also be checked:-- resistance between pins 1 and 2 = 3.3K Ω resistance between pins 2 and 3 = 2.5K Ω resistance between pins 1 and 3 = 2.5K Ω If the sensor is to specification continue with step 4. 4. Wiring faulty A. Check the wiring from the the engine ECU to the sensor connector X371. With the keystart ON, +5V should be measured on pin 2 of sensor connector X371. If ZERO volts is indicated check for an Open Circuit or Short to ground back to the engine ECU , connector X192, pin 23. Trace fault and repair wiring as required. If wiring to pin 2 is okay continue with step B. B.

With the keystart OFF, continuity to ground should be indicated on pin 3 of sensor connector X371. If no ground is indicated, check for an Open circuit back to the engine ECU, connector X192, pin17. Trace fault and repair wiring as required. If wiring to pin 3 is okay continue with step C. C. With the keystart ON, check pin 1 for a short to +12V. If +12V is indicated trace fault and repair wiring to pin 1. If okay check for an open circuit back to engine ECU, connector X193, pin 12. Check also for a short to ground. If any fault is indicated trace and repair the wiring as required. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) B.20.A / 106