POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0401.2 FUEL TEMPERATURE SENSOR, DATA INCORRECT 0401.3 FUEL TEMPERATURE SENSOR, SHORT TO HIGH SOURCE 0401.4 FUEL TEMPERATURE SENSOR, SHORT TO LOW SOURCE Cause: No signal or signal range outside threshold limits Signal not plausible or intermittent fault Effect on Engine: Engine enabled -- no restriction on fuel or speed Possible failure modes: 1. Faulty fuel temp sensor B36 2. Faulty connector X372 or wiring Solution: 1. Check connector X372 at sensor B36. A. Ensure the connector, X372, is not damaged, the terminals are in the correct position in the housing, and that the fit is tight on the sensor.
Repair or replace damaged components as required. B. If the connector is okay continue with step 2. 2. Check fuel temp sensor B36. A. To test the sensor the voltage needs to be read between the output wire, pin 1 and the sensor ground, pin 2, of the connector X372. Using a suitable probe into the wire, the voltage should range from 0.6--2.4V between 60 ° --90 ° C. If there is voltage but out of range replace sensor, if Zero volts is indicated continue with step B. B. Remove the connector X372 and check the sensor using a suitable multi-meter.
Measure the resistance across the sensor terminals, the resistance should vary between 8--10k Ω @--10 ° C , 2.2--2.7k Ω @20 ° C and 0.29--0.36k Ω @80 ° C . Check for a short to ground between each sensor terminal and the engine block, an open circuit should be recorded on each terminal. If any readings are incorrect replace the sensor. If the sensor is okay continue with step 3. 3. Check wiring A. Disconnect the sensor connector X372. With the keystart switch ON, measure the voltage at pin 2, +5V should be measured. If no voltage is measured check the wiring for continuity between Pin 2 of the sensor connector X372 and pin 11 of engine ECU connector X192. Repair wiring as required.
Check for voltage on Pin 1, 0V should be measured. If voltage is measured trace and repair short circuit in wiring between Pin 1 of the sensor connector X372 and Pin 6 of the engine ECU connector X192. With the keystart OFF, also check for continuity of the wire between Pin 1 of the sensor connector X372 and Pin 6 of the engine ECU connector X192, and for a short to ground. Trace fault and repair as required. B. If the wiring is okay suspect a faulty engine ECU. Download engine software using the electronic service tool and operate engine. If fault still occurs substitute engine ECU. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) B.20.A / 108