Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0408.2 ENGINE OVERSPEED, DATA INCORRECT 0408.3 ENGINE OVERSPEED, SHORTED TO HIGH SOURCE 0408.4 ENGINE OVERSPEED, SHORTED TO LOW SOURCE Cause: Engine has exceeded the overspeed limit Effect on Engine: Engine enabled -- no restriction on fuel or speed Possible failure modes: 1. Speed sensors faulty 2. Faulty Vehicle electronic control unit (CCM2) software or hardware Solution: 1. Check the engine flywheel rpm sensor B05. A. Using a suitable multi-meter check across the speed sensor terminals at connector X369 for a short circuit or an open circuit and between each terminal for a short to ground.

If any of the above conditions exist, replace the engine flywheel rpm sensor. The sensor resistance value is 820--920K Ω between the terminals 1 and 2. B. If the sensor appears to be okay continue with step 2. 2. Check the engine camshaft rpm sensor B07. A. Using a suitable multi-meter check across the speed sensor terminals at connector X370 for a short circuit or an open circuit and between each terminal for a short to ground. If any of the above conditions exist, replace the engine camshaft rpm sensor. The sensor resistance value is 820--920K Ω between the terminals 1 and 2. B. If the sensor appears to be okay continue with step 3. 3. Check CCM2 controller. A.

Check the hardware of the CCM2 controller. Remove and inspect the connectors, check the installation of the controller to the vehicle frame, check the ground connections for the controller and check the power feeds from fuse 36 and fuse 37. Repair / replace any damaged items. B. Check the software installed in the controller on the Universal Display Plus screen. If the Universal Display Plus monitor is indicating software installed and has no CCM2 ECU errors, download the correct level software again into the controller. Operate the engine, if the error re-occurs substitute the CCM2 controller. NOTE: If CCM2 ECU errors are indicated rectify these errors first.

Refer to the CCM2 fault code charts. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) Wiring harness -- Electrical schematic frame 28 (A.30.A.88 -- C.20.E.28) Wiring harness -- Electrical schematic frame 29 (A.30.A.88 -- C.20.E.29) B.20.A / 111