Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0412.2 INK SIGNAL, DATA INCORRECT 0412.3 INK SIGNAL, SHORTED TO HIGH SOURCE 0412.4 INK SIGNAL, SHORTED TO LOW SOURCE Cause: Primary (flywheel) engine speed sensor B05 Effect on Engine: Fuel restricted and speed restricted to 1500 rev/min. Possible failure modes: 1. Speed sensor faulty 2. Wiring to speed sensor faulty Solution: 1. Check the engine flywheel rpm sensor B05. A. Using a suitable multi-meter check across the speed sensor terminals at connector X369 for a short circuit or an open circuit and between each terminal for a short to ground. If any of the above conditions exist replace the engine flywheel rpm sensor.

The sensor resistance value is 820--920K Ω between the terminals 1 and 2. B. If the sensor appears to be okay continue with step 2. 2. Check the engine speed sensor to flywheel air gap. The gap should be 0.5--1.5mm. NOTE: The air gap is a set dimension determined by design and is not adjustable. The only reason the air gap will be incorrect is if damage has occurred to either the speed sensor or flywheel or if the sensor has been incorrectly installed. A. Remove the engine flywheel speed sensor and inspect for damage or a build up of dirt. With the sensor removed also inspect the flywheel for damage. If any damage is evident replace the component. B.

If the engine speed sensor to flywheel air gap is correct continue with step 3. 3. Check the wiring to the speed sensor. A. With the keystart switch OFF, disconnect the engine flywheel rpm sensor connector X369 and connector X192 of the engine ECU. Using a suitable multi-meter check for continuity between pin 1 of the speed sensor and pin 1 of the engine ECU connector. Also check for continuity between pin 2 of the speed sensor and pin 13 of the engine ECU connector. If an open circuit is indicated trace the fault and repair the wiring as required. B.

With the keystart switch OFF, and the engine flywheel rpm sensor connector X369 and connector X192 of the engine ECU still disconnected check for a short to ground on each of the speed sensor pins. If a short to ground is indicated trace the fault and repair the wiring as required. C. With the engine flywheel rpm sensor connector X369 and connector X192 of the engine ECU still disconnected, turn the keystart ON, (not cranking), and check for a short to +12V on each of the speed sensor pins. If a short to +12V is indicated trace the fault and repair the wiring as required. D. With the keystart switch OFF, reconnect the engine ECU connector.

Turn the keystart ON, (not cranking), and check for approximately 0.25V at the speed sensor connector X369, pin 1. If 0.25V is not indicated replace the engine ECU. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) B.20.A / 113