Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0413.2 SEG SIGNAL, DATA INCORRECT 0413.3 SEG SIGNAL, SHORTED TO HIGH SOURCE 0413.4 SEG SIGNAL, SHORTED TO LOW SOURCE Cause: Secondary (camshaft) engine speed sensor B07 NOTE: This fault will occur only when engine is running. Effect on Engine: Fuel restricted and speed restricted to 1500 rev/min. Possible failure modes: 1. Speed sensor faulty 2. Wiring to speed sensor faulty Solution: 1. Check the engine camshaft rpm sensor B07. A. Using a suitable multi-meter check across the speed sensor terminals at connector X370 for a short circuit or an open circuit and between each terminal for a short to ground.

If any of the above conditions exist replace the engine camshaft rpm sensor. The sensor resistance value is 820--920K Ω between the terminals 1 and 2. B. If the sensor appears to be okay continue with step 2. 2. Check the camshaft speed sensor to phonic wheel air gap. The gap should be 0.5--1.5mm. NOTE: The air gap is a set dimension determined by design and is not adjustable. The only reason the air gap will be incorrect is if damage has occurred to either the speed sensor or phonic wheel or if the sensor has been incorrectly installed. A. Remove the camshaft speed sensor and inspect for damage or a build up of dirt. With the sensor removed also inspect the camshaft for damage.

If any damage is evident replace the component. B. If the camshaft speed sensor to phonic wheel air gap is correct continue with step 3. 3. Check the wiring to the speed sensor. A. With the keystart switch OFF, disconnect the engine camshaft rpm sensor connector X370 and connector X192 of the engine ECU. Using a suitable multi-meter check for continuity between pin 1 of the speed sensor and pin 2 of the engine ECU connector. Also check for continuity between pin 2 of the speed sensor and pin 14 of the engine ECU connector. If an open circuit is indicated trace the fault and repair the wiring as required. B.

With the keystart switch OFF, and the engine camshaft rpm sensor connector X370 and connector X192 of the engine ECU still disconnected check for a short to ground on each of the speed sensor pins. If a short to ground is indicated trace the fault and repair the wiring as required. C. With the engine camshaft rpm sensor connector X370 and connector X192 of the engine ECU still disconnected, turn the keystart ON, (not cranking), and check for a short to +12V on each of the speed sensor pins. If a short to +12V is indicated trace the fault and repair the wiring as required. D. With the keystart switch OFF, reconnect the engine ECU connector.

Turn the keystart ON, (not cranking), and check for approximately 0.25V at connector X370 pin 1 of the speed sensor. If 0.25V is not indicated replace the engine ECU. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) B.20.A / 115