Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0419.2 CYLINDER 5, DATA INCORRECT 0419.3 CYLINDER 5, SHORTED TO HIGH SOURCE 0419.4 CYLINDER 5, SHORTED TO LOW SOURCE Cause: Injection circuit fault Effect on Engine: Engine speed restricted and only operating on 5 cylinders Possible failure modes: 1. Faulty injector 2. Wiring fault between injector and engine ECU. Solution: 1. Check the connector at the Injector. A. Ensure the connector is not damaged, the terminals are in the correct position in the housing, and that the fit is tight on the injector. NOTE:

The separate injector harness assembly is specially constructed to avoid interference from electromagnetic sources, therefore no repairs should be attempted on this harness. If the connector or wiring is damaged it will be necessary to replace the complete injector harness assembly. B. If the connector is okay continue with step 2. 2. Check the injector. A. With the connector removed, measure the resistance across the injector coil terminals. The resistance should be 0.56--0.57 Ω . If the coil is outside the range or indicates either a short or open circuit, replace the injector assembly. B. If the injector is okay continue with step 3. 3.

Check the wiring between the injector and Engine ECU. NOTE: A common positive is supplied to groups of three injectors. Injectors for cylinders 1, 2 and 3 are supplied from pin 24 of X192 (engine ECU) and injectors for cylinders 4, 5 and 6 are supplied from pin 25 of X192 (engine ECU). A. Disconnect the injector harness and engine ECU connector X192. Using a suitable multi-meter check the injector control wiring between pin I of the injector harness connector and pin 28 of X192, engine ECU. Check the wiring for continuity and short to ground. Repair/replace the wiring if a fault is found. If no fault is found continue with step B. B. Reconnect connector X192 to the engine ECU.

With the keystart ON (not cranking), check for a short to +12V at pin I of the injector harness connector. If a short to +12V is indicated trace the fault and repair the wiring as required. If +12V does not exist continue with step C. C. With the keystart OFF, check the wiring on the separate injector harness assembly. Using a suitable multi-meter check across pins I and L, with the injector still connected, the resistance should be approximately 0.56--0.57 Ω . Having previously eliminated the injector coil, if an open or short circuit is indicated the fault is in the harness. Replace the harness. Wiring harness -- Electrical schematic frame 03 (A.30.A.88 -- C.20.E.03) B.20.A / 127