POWER PRODUCTION - AIR INTAKE SYSTEM Sensing system Air cleaner restriction - Open circuit (B.30.A.95.95 - G.30.B.50) AFX8010 E0163-05 - Air Filter Sensor Cause: The engine air filter switch (S-61) circuit is open or shorted to ground. Possible failure modes: 1. Switch signal wiring open or shorted to ground. 2. Loss of power to the switch. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "AIR FILTER SEN" to check the voltage range. The proper voltage range for the engine air filter switch (key On, engine Off or Running) is - 0.3 - 5.2 volts . A.
If the voltage reading is low out of range continue with Step 2 . B. If the voltage is normal the shorted wire may not be grounded at this time. Continue with Step 8 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the resistor plug at connector X330 . Use a multimeter to check for voltage on connector X330 pin B. There should be 5 volts present. A. If no voltage is found, continue with Step 3 . B.
If correct voltage is found, continue with Step 5 . 3. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a multimeter to check for voltage on the main frame (MF) harness end of connector X010 pin 13. There should be 5 volts present. A. If voltage is found, there is an open circuit in the engine (EN) harness between connector X330 pin B and connector X010 pin 13 wire 469 pink or 463 pink. Locate the open and repair. B. If no voltage is found, continue with Step 4 . 4. Carefully disconnect the main frame (MF) harness from the CCM2 module at connector X016 . Use a multimeter to check for voltage on the CCM2 module connector X016 pin J2-31.
There should be 5 volts present. A. If voltage is found, there is an open circuit in the main frame (MF) harness between connector X010 pin 13 and connector X016 pin J2-31 wire 459 pink or 463 pink. Locate the open and repair. B. If no voltage is found, there is an internal fault with the CCM2 module. Replace the module. 5. Disconnect the air filter pressure switch connector X202 and resistor plug at connector X330 . Use a multimeter to check for continuity between connector X202 pin 2 and chassis ground. A. If there is continuity to ground, continue with Step 6 . B. If there is no continuity to ground, continue with step 7 . 6.
Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a multimeter to check for continuity between the main frame harness end of connector X010 pin 8 and chassis ground. 9673 1 27/05/2004 B.30.A / 24