Case IH AFX8010 — AIR INTAKE SYSTEM

POWER PRODUCTION - AIR INTAKE SYSTEM 3. Wiring faulty A. Check the wiring from the engine ECU to the sensor connector. With the keystart ON, +5V should be measured on pin 1 of sensor connector X374 (+5V common line). If ZERO volts is indicated check for an Open Circuit or Short to ground back to the engine ECU , connector X192 , pin 21. Trace fault and repair wiring as required. If wiring to pin 1 is okay continue with step B. B. With the keystart OFF, continuity to ground should be indicated on pin 2 of sensor connector X374 (ground common line). If no ground is indicated, check for an Open circuit back to the engine ECU, connector X192 , pin 4. Trace fault and repair wiring as required. A.

With the keystart ON, check pin 2 for a short to +12 volts . If +12 volts is indicated trace fault and repair wiring to pin 2. Sensing system Air temperature sensor - Overview (B.30.A.95.80 - C.10.A.10) 40033790D4 1 The Air Temperature Sensor B-54 (1) monitors the temperature of the air in the intake manifold and sends the information to the ECU module connector X192 pins 4 & 21. This information is used by the ECU module to control engine fuel delivery. This circuit is monitored by the ECU module; in the event that a fault occurs with the sensor itself or the wiring to the sensor, a fault code will be displayed to the operator.

E0400-02 Boost Air Temperature Data Incorrect E0400-03 Boost Air Temperature Short to High Source E0400-04 Boost Air Temperature Short to Low Source For additional information on the air temperature sensor electrical circuit, refer to: Wiring harness - Electrical schematic frame 03 (A.30.A.88 - C.20.E.03) 9673 1 27/05/2004 B.30.A / 30