MULTICYLINDER ENGINES 105 cooling system with coolant as described in Chapter Three. CYLINDER HEAD Removal In some instances, the cylinder head may be removed for service without removing the engine. If engine re- moval is necessary, refer to the engine removal procedure. Refer to Figure 8 for an exploded view of the cylinder head assembly. To remove the cylinder head, proceed as follows: 1. Disconnect the negative battery cable from the nega- tive battery terminal. 2. If not previously performed, drain the cooling system as described in Chapter Four. 3. Remove the alternator as described in Chapter Eight. 4. Remove the exhaust manifold as previously described. 5.
Disconnect the wire lead from the water temperature sender (Figure 9). 6A. Engines with standard cooling-Disconnect the lower water hose (Figure 9) from the thermostat housing. 6B. Engines with freshwater (closed) cooling sys- tem-Remove the freshwater pump as described in Chap- ter Eight. 7. Remove the air cleaner and the air cleaner base. 8. Remove the fuel injector and precombustion chamber as described in Chapter Seven. 9. Remove the valve cover as previously described. 10. Remove the nuts that retain the rocker arm stands (Figure 10), then remove the rocker shaft assembly. 11. Remove the push rods and mark them so they can be reinstalled in their original positions. 12.
Detach the oil line fitting from the cylinder head. 13. Unscrew the smaller cylinder head retaining bolts first, then unscrew the larger bolts and nuts in a crossing pattern. 14. Remove the cylinder head and head gasket. 6. Clean any gasket residue from the exhaust manifold and cylinder head. 7. Remove the exhaust manifold cover retaining screws and remove the manifold cover (Figure 7). 8. Inspect the exhaust manifold and cover for warpage, carbon buildup and corrosion. 9. Reinstall the exhaust manifold and cover by reversing the removal procedure. Tighten the retaining nuts to the torque specified in Table 2.
2GMF, 2GM20F, 3GMF, 3GM30F, 3HMF and 3HM35F models with freshwater (closed) cooling system Refer to Figure 6. 1. Refer to Chapter Four and drain the cooling system. 2. Detach the exhaust hose from the exhaust elbow. 3. Remove the water hose from the exhaust manifold and thermostat housing. 4. Remove the water hose from the exhaust manifold and freshwater pump. 5. Disconnect the water hoses from the manifold end caps. 6. Disconnect the water hose to the overflow tank. 7. Remove the exhaust manifold from the cylinder head. 8. Clean any gasket residue from the exhaust manifold and cylinder head. 9. Check the exhaust manifold for warpage, carbon buildup and corrosion. 10.
Ifnecessary, refer to Chapter Eight to service the heat exhanger inside the exhaust manifold. 11. Reverse the removal procedure to install the exhaust manifold. Tighten the manifold bolts to the torque speci- fied in Table 2. Fill the freshwater section of the closed Inspection 1. Refer to the Anticorrosion Maintenance section in Chapter Three. Remove and inspect the sacrificial anode. Install the anode in the cylinder head after completing cyl- inder head service. 2. If service to the valves or rocker assembly is required, refer to the Valves and Rocker Assembly sections. 3. Check the cylinder head for signs of oil or water leak- age before cleaning.
Look for corrosion or foreign mate- rial in the oil and water passages.