140 CHAPTER SEVEN Individual pumping elements are used on sin- gle-cylinder engines as shown in Figure 4. Multi- ple-cylinder engines are equipped with pumping elements combined in a single unit as shown in Figure 5. Fuel injection pumps are precision-built units that re- quire clean fuel to operate properly. The extremely close tolerances and high injection pressure dictate that special- ized equipment and experienced technicians are needed to service fuel injection pumps. If properly operated and maintained, a fuel injection pump will provide long-lasting, trouble-free service.
Injection nozzle Fuel Injector Fuel storage tank A fuel injector (A, Figure 6) is required for each cylin- der to inject fuel into the combustion chamber. A high-pressure fuel line (B, Figure 6) directs fuel from the fuel injection pump to the fuel injector, while a fuel return line (C, Figure 6) carries bypass fuel back to the fuel tank. Refer to Figure 7 for an exploded view of the fuel injec- tor. The engines covered in this manual are equipped with an inward opening, throttling-pintle type fuel injector (Figure 8). High fuel pressure from the injection pump enters the injection nozzle, surrounds the nozzle valve and forces the valve away from the seat.
The pressure exerted by the spring above the nozzle holds the nozzle valve closed until the pressure of the fuel rises higher than spring pressure. The fuel delivered by the pump sprays from the nozzle tip into the combustion chamber when the valve opens. After the fuel is injected, fuel pressure de- creases and the spring once again closes the valve. The injection nozzle atomizes the fuel to help mix fuel with the compressed air in the engine's cylinder. The fuel must be broken into very small particles so that the fuel will quickly absorb heat from the compressed (hot) air, change to a vapor, then ignite. The design ofthe nozzle tip affects the size and shape of the fuel spray.
The throttling pintle reduces the amount of fuel injected for a given ori- fice and causes a delay in the injection of the principal amount of fuel. Excess fuel is routed from the injectors back to the fuel tank through a fuel return line. jection pump and nozzles are easily damaged by solid par- ticles in the fuel as well as by water in the fuel. All diesel fuel contains some sulfur, which forms sulfu- ric acid if water mixes with the sulfur. The sulfuric acid will quickly erode the precision parts of the pump and nozzles. Extra care must be exercised in the storage and handling of diesel fuel to prevent contamination.
Diesel fuel is graded according to the composition of the fuel after passing through the refining process. Com- mon diesel fuel grades are ID and 2D, with ID the lighter fuel. The recommended fuel for the Yanmar engines cov- ered by this manual is 2-D diesel fuel. Filters are included within the system to remove solid particles and absorb moisture. In many cases, at least two filtering stages plus a water trap are incorporated to help ensure only clean fuel reaches the fuel injection pump. The primary filter (nearest the fuel tank) removes sedi- ment and water from the fuel. The secondary filter re- moves very fine particles from the fuel.
Both filters must Fuel and Fuel Filters Clean, moisture-free fuel is very important to a diesel fuel system. As well as acting as the fuel for combustion, diesel fuel is also a lubricant for many ofthe internal mov- ing parts in the fuel system. The close tolerances ofthe in-