Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

142 CH A P TE R SEVEN be operating properly to adequately protect the fuel injec- tion system. Failure to maintain fuel fillers and use clean fuel can result in engine stoppage and expensive replace- ment or repair of the injection pump or injectors. Fuel Tr ansf er Pump The fuel transfer pump (A, Figure 9) moves fuel from the fuel lank to the fuel injection pump. The pump is nec- essary when the fuel tank is lower than the fuel injection pump. A primer lever on the side of the trans fer pump per- mits manual operation of the fuel pump diaphragm. Priming or bleeding the fuel system requires operation of the primer lever so fuel flows to the injection system with the engine slopped.

FUEL I."' JECTIOI\ S YSTE:vJ BLEEIlING Air in the fuel system can cause rough engine operation or stoppage. Bleeding purges air from the system. Bleed the system anytime fuel line connections are disconnected or fuel components are removed. To ensu re all air is re- moved, perform the complete bleeding procedure de- scribed in the following steps: I. Open the bleed screw on the fuel filter (Figure 10). Make sure the fuel valve on the fuel tank is open. NOTE Be prepared to contain and IVI/ )e up expelled file!. 3. Open the air bleed screw (Figure II) on the fuel injec- tion pump. 2.

Ope rate the priming lever (8, Figure 9) on the fuel transfer pump while observing the fuel expelled from the bleed screw hole. Continue to operate the priming lever until air-free fuel is expelled, then close the air bleed screw. 4. Operate the priming lever ( 8, Figure 9) on the fuel transfer pump while observing the fuel expelled from the bleed screw hole. Continue to operate the priming lever until air-free fuel is expelled, then close the air bleed screw.