Chapter Eight Cooling System 8 NOTE Except where s pec ified. F and D series en- gine s are included when a basic model num - ber is specified. For example, if model 3GM is called out in a procedure. the procedure also applies 10 3GMD and 3GMF. COOLl:'\G SYSTEMS Seawater (Sta ndard) Cooling Syste m All engines arc equipped with a seawater cooling sys- tem. The water in which the boat is being operated is used as a coolant to absorb engine heat. Water from outside the boat passes through the water intake to the impeller-type seawater pump located on the engine (Figure I , typical). The seawater pump sends the water to the engine for cir- culation through the engine block. head and manifold.
This chapter covers service procedures for the thermo- stat, engine wate r pump, seawater pumps, drive belts and connecting hoses in both standard and closed cooling sys- tems. Cooling system flushing procedures are provided in Chapter Three. Drain and refill procedures are described in Chapter Four. A thermostat controls water circulation to provide quick engine warm-up and maintain a constant operating temperature. Table I and Tab le 2 are located at the end ofth is chap- ter. R ef er to typical cooling system diagrams in Figure 2. Fig ure 3 and Figure 4.