COOLING SYSTEM 163 o CLOSED COOLING SYSTEM DIAGRAM Pressure fill cap Remote tanktrr;;;;;;;;1~~~~~~~~~~ Heat exchanger By-pass Freshwater pump Thermostat Freshwater reservoir Mixing elbow Cylinder head Seawater line Cylinder block Seacock Freshwater line ~ Seawater Freshwater (Closed) Cooling System system operation is similar to the standard cooling system previously described, except as follows: a. Coolant in the closed cooling system cools the en- gine block, cylinder head and exhaust manifold. b. A belt-driven seawater pump (Figure 1), located at the front of the engine, delivers seawater to the heat exchanger, instead of passing seawater directly into the engine.
After passing through the seawater pump, the seawater travels through a series of parallel copper tubes in the heat exchanger, where it absorbs engine heat before returning to the exhaust elbow for discharge from the boat. Figure 7 shows a typical heat exchanger. The freshwater system pump circulates the coolant mixture inside the engine to absorb engine heat. This Two- and three-cylinder engines with a model number ending in F are equipped with seawater and freshwater (closed) cooling systems The closed cooling system is divided into two separate subsystems: one uses seawater and the other uses a cool- ant mixture of distilled water and ethylene glycol anti- freeze.
The subsystem containing the coolant is referred to as the freshwater system. Refer to the typical freshwa- ter cooling system diagram in Figure 5. Typical compo- nents are shown in Figure 6. Various configurations of the closed cooling system are used, but all function essentially the same. The seawater