Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

COOLING SYSTEM 181 Hose Index pin End ' __ ~~I~End ~1 -~ 4. Remove the heat exchanger (Figure 38). NOTE If the heat exchanger isplugged or contains heavy scale deposits, take it to a marine dealership or automotive radiator repair shop for proper cleaning to avoid potential damage to the unit. Heat exchanger 5. Clean all gasket residue from the end caps and heat exchanger sealing surfaces. 6. Insert an appropriate-size wire brush into each passage in the heat exchanger. Work the brush back and forth with a vigorous motion, but work carefully to avoid damage to the soldered joints. 7. Remove the brush, hold the heat exchanger vertically and blow loosened particles out with compressed air. 8.

Repeat Step 6 and Step 7 as necessary to remove as much of the accumulated deposits as possible. 9. Reinstall the heat exchanger by reversing the removal procedure. Position the heat exchanger so the index pins (Figure 39) in both ends fit in the holes in the end caps. 10. Fill the freshwater section with coolant. Refer to Chapter Three. Start the engine and check for leaks. O-rings heating. It is recommended to remove and clean the heat exchanger whenever the coolant is changed. Refer to Fig- ure 36. 1. Drain both sections of the cooling system. Refer to Chapter Four. Loosen the hose clamps and disconnect the seawater inlet and outlet hoses from the end caps (Figure 37). 2.

Remove the end cap retaining bolts. 3. Remove the heat exchanger end caps. Remove and dis- card the gaskets. SEAWATER COOLING SYSTEM MAINTENANCE The only maintenance required for the seawater cooling system is periodic flushing. Refer to Chapter Three.