Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

Chapter Ten Transmission-KM Series Basic design is the same for all the transmissions with the exception of the shifting mechanism. Transmissions 1 _ with a P suffix are equipped with a shifting device that en- gages detent notches in the shifter housing. All other mod- els use spring-loaded pins and a spring-loaded actuator that engage detents and ramps on the shift shaft. 10 Refer to Chapter Three for maintenance information. Tabl es 1-7 are located at the end of this chapter. O PERA TIO N The input shaft on the transmission engages the drive disc attached to the engine flywheel. Because this is a con- stant-mesh transmission, engine power is transmi tted to all gears .

Power flows to the output shaft when the cone clutch engages either the fore .... ard gear or the reverse gear. In Figure 2, the cone clutch is shown engaged with the forward gear. Because power flows from the input shaft gear through the reverse idler gear to the reverse gear, the reverse gear rotates in the opposi te direction of the for- ward gear. When the cone clutch engages the reverse gear, the output shaft rotates in reverse . This chapter covers the Kanzaki KM2A, KM2C, KM2P, KM3A and KM3P marine transmissions that are attached to Yanmar lGM, IGM IO, 2GM, 2GM20, 3GMD and 3GM30 engines. Refer to Table I for a cross-reference of engine and transmission models.

The identification plate located on the transmission case (Fig- ur e I , typica l) specifies the transmission model. The KM2 and KM3 series transmissions are inline transmissions that provide forward and reverse direction. All gears are constant mesh. A cone-type clutch engages internally tapered gears to transmit power to the output shaft. Oil contained in the transmission case lubricates the internal transmission components. On Model KM2A, KM2C and KM3A transmissions, moving the shift lever (Figure 3) rotates the shift shaft. When the shift shaft rotates, the shifter slides the cone clutch into engagement with the forward or reverse gear, or into neutral.

When the shifter reaches the proper posi- tion, the upper spring- loaded detent pin sits on a ramp that