TRANSMISSION-KBW SERIES 223 11. Fit the key (4, Figure 3) into the slot on the output shaft so the fillet side of the key faces the threaded end of the output shaft. 12. Install the pressure plate, with the ball slots facing up, so the steel plate tangs fit into the three slots in the pres- sure plate. Make sure the pawls of a 11 three steel plates en- gage the pressure plate. 13. Install three steel balls into the slots on the pressure plate. Install the drive plate onto the output shaft so the side of the drive plate with concentric groove is facing the forward gear assembly.
Make sure all three steel balls.re- main in place and the grooves ofthe pressure plate and the drive plate match when the drive plate is installed. 14. Insert both locating pins into the drive plate so they engage the torque limiter slots of the pressure plate. 15. Install the shim, spacer and inner needle bearing race on the ouput shaft using a suitable bearing driver. 16. Insert the detent pins and springs into the drive plate. Install the shift ring over the drive plate so the three legs with grooves are facing the forward gear and the detent pins in the drive plate properly engage the pin slots of the inside diameter of the shift ring. 17.
Install three steel balls in the slots of the drive plate and place the pressure plate over the drive plate. Make sure the steel balls remain in position and the slots of both plates match. 18. Install the pressure plate return springs between the shift ring and the drive plate. Attach the spring ends to the small holes inside the pressure plates as shown in Figure 14. 19. Install the reverse gear assembly so the tangs of all three steel plates properly engage the slots in the pressure plate. 20. Install the needle bearing and thrust washer with the copper sintered side of the washer facing the reverse gear. 21.
Using a suitable bearing driver install the rear output shaft inner race onto the output shaft. Make sure the race bottoms against the thrust washer. 22. Check for smooth rotation of both the forward and re- verse gears. Check for correct operation of the shift ring. Retainer Belleville springs Bearing A Spacer Return spring 7. Install the thrust washer on the output shaft with the sintered copper surface facing away from the bearing. Shifter 8. Using a suitable bearing driver, install the needle bear- ing inner race on the output shaft. Be sure the race bottoms against the thrust washer. Refer to Figure 3.
NOTE Make alignment marks on the shift lever and shift shaft so the shift lever can be rein- stalled in its original position. 9. Install the needle bearing, spacer and shim on the out- put shaft. 10. Install the forward gear assembly on the output shaft and align the steel plate tangs. 1. Loosen the clamp bolt and remove the shift lever. 2. Remove the shift cam.