Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSMISSION- KBW SERIES 225 4. Measure the distance (A, Figu re IS) in millimeters from the mounting flange mating surface on the case to the top of each bearing race. Rec ord the measurements. 5. Measure the distance (B. Figure 16) from the mount- ing flange mating surface to the bottom of the bearing race bore for both the input and output shaft bearings. 6. Subtract the A measurement from the B measurement for each shaft. 7A. Input shaft- From the result obtained in Step 6. sub- tract 0.0-0.05 mm. This result equals the thickness of the shim(s) that must be installed in the bearing bore in the mounting flange. 7 8. Output shaft- From the result obtained in Step 6, sub- tract 0.0-0.1 mm.

This result equals the thickness of the shim(s) that must be installed in the bearing bore in the mounting flange. 8. Install the shim(s) in the bearing bore in the mounting flange, then press the bearing outer race into the mounting flange on top of the shims. Be sure the race is bottomed . shaft. Bolts secure the disc to the flywheel while the trans- mission input shaft engages the splincd hub on the drive disc. The drive disc incorporates springs that dampen driveline shocks between the engine and transmission. 11 Remova l/Install ati on I. Remove the engin e from the boat. 2. Remove the transmission. 3. Remove the drive disc (Ffg ure 17, typical). 4.

Install the drive disc by reversing the removal proce- dure. Install the drive disc so the side marked FLYWH EEL SID E (Figure 18) is towa rd the flywheel. Tighten drive disc retaining bolts to the lorque spec ified in Table 2. Inspection Replace the drive disc if any of the following conditions exist: DRIVE DISC I. Broken spring. 2. Wom or damaged splines in hub. 3. Damaged disc . .4. Damaged pins. The drive disc attached to the engine flywheel transmits power from the engine flywheel to thc transmission input