SNAPSHOT EXAMPLES EGR Flow at Idle Detroit Diesel EGR Engines will flow EGR @ idle, as certain conditions are met. MY-2002 EGR engines will flow EGR for a short duration if DDEC determines a quick rise (snap-acceleration) in engine rpm’s over time. Engine parameters programmed determine the duration of EGR flow. There is a time duration difference between MY-2002/03 - 2004. Delta P Sensor and Piping The Delta P sensor monitors the pressure differential across the venturi by readings from the two openings in the delivery pipe.
High Delta P with NO Flow Demand (PWM2 % = 7) If the EGR valve is closed (7%) and the EGR temperature is between inlet manifold and engine temperature there should be little to no actual EGR flow. If the Delta P sensor is registering a high differential pressure in this condition: Check for the pressure signal pipe of hose to one side of the sensor is plugged or leaking (includes sensor mounting o rings). The sensor being defective is the least likely. Incorrectly wired (replacement sensor). Low Delta P with Flow Demand (PWM2 % greater than 7 and less than 90) If the EGR valve is open and the EGR temperature is elevated there should EGR flow.
If the Delta P sensor is registering a low differential pressure in this condition: it is likely that the pressure signal to both sides of the sensor are plugged or leaking Lastly, a defective sensor. Stuck or Sticking VNT or EGR Valve Actuator When the actuator is sticking, DDEC can’t control turbocharger speed or EGR flow smoothly. Turbocharger speed and PWM 4- VNT % will fluctuate greatly. If the EGR actuator is sticking you are able to see EGR flow with the PWM2 % staying at 7% (which is closed). The engine's temperature can be a factor in this operation. DDEC is attempting to control turbocharger speed and is overcompensating with PWM4 in an attempt to control turbocharger speed.
7-2 All information subject to change without notice. (Rev. April 2004) 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION