SEBU7901-01 23 Operation Section Lifting and Storage Operation Section i02068367 Product Storage Lifting and Storage SMCS Code: 1000; 1404; 7002 If the engine will not be started for several weeks, the lubricating oil will drain from the cylinder walls and from the piston rings. Rust can form on the cylinder liner surface. Rust on the cylinder liner surface will cause increased engine wear and a reduction in engine service life. i01988813 Product Lifting SMCS Code: 1000; 1404; 7002 To help prevent excessive engine wear, use the following guidelines:
Complete all of the lubrication recommendations that are listed in this Operation and Maintenance Manual, “Maintenance Interval Schedule” (Maintenance Section). If freezing temperatures are expected, check the cooling system for adequate protection against freezing. See this Operation and Maintenance Manual, “Refill Capacities and Recommendations” (Maintenance Section). g00103219 Illustration 19 If an engine is out of operation and if use of the engine is not planned, special precautions should be made. If the engine will be stored for more than one month, a complete protection procedure is recommended. NOTICE Never bend the eyebolts and the brackets.
Only load the eyebolts and the brackets under tension. Remem- ber that the capacity of an eyebolt is less as the angle between the supporting members and the object be- comes less than 90 degrees. For more detailed information on engine storage, see Special Instruction, SEHS9031, “Storage Procedure For Caterpillar Products”. When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight. Your Caterpillar dealer can assist in preparing the engine for extended storage periods. Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the engine.
All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted. Some removals require lifting the fixtures in order to obtain proper balance and safety. To remove the engine ONLY, use the lifting eyes that are on the engine. Lifting eyes are designed and installed for the specific engine arrangement. Alterations to the lifting eyes and/or the engine make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Caterpillar dealer for information regarding fixtures for proper engine lifting.