SEBU7901-01 53 Maintenance Section Aftercooler Core - Clean/Test i01188617 Aftercooler Core - Clean/Test (Air-To-Air Aftercooler) Note: If parts of the aftercooler system are repaired or replaced, a leak test is highly recommended. The FT1984 Aftercooler Testing Group is used to perform leak tests on the aftercooler. Refer to the Systems Operation/Testing and Adjusting, “Aftercooler - Test” and the Special Instruction, SEHS8622 for the proper testing procedure. SMCS Code: 1064-070; 1064-081 Note: Adjust the frequency of cleaning according to the effects of the operating environment. Inspect these items for good condition: welds, mounting brackets, air lines, connections, clamps, and seals.
Make repairs, if necessary. Inspect the cooling air side of the aftercooler for these items: damaged fins, corrosion, dirt, grease, insects, leaves, oil, and other debris. Clean the cooling air side of the aftercooler, if necessary. For more detailed information on cleaning and inspection, see Special Publication, SEBD0518, “Know Your Cooling System”. For air-to-air aftercoolers, use the same methods that are used for cleaning the outside of radiators. i00072207 Alternator - Inspect Personal injury can result from air pressure. SMCS Code: 1405-040 Personal injury can result without following prop- er procedure. When using pressure air, wear a pro- tective face shield and protective clothing.
Caterpillar recommends a scheduled inspection of the alternator. Inspect the alternator for loose connections and proper battery charging. Inspect the ammeter (if equipped) during engine operation in order to ensure proper battery performance and/or proper performance of the electrical system. Make repairs, as required. Refer to the Service Manual. Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes. Pressurized air is the preferred method for removing loose debris. Direct the air in the opposite direction of the fan’s air flow. Hold the nozzle approximately 6 mm (0.25 inch) away from the fins.
Slowly move the air nozzle in a direction that is parallel with the tubes. This will remove debris that is between the tubes. Check the alternator and the battery charger for proper operation. If the batteries are properly charged, the ammeter reading should be very near zero. All batteries should be kept charged. The batteries should be kept warm because temperature affects the cranking power. If the battery is too cold, the battery will not crank the engine. The battery will not crank the engine, even if the engine is warm. When the engine is not run for long periods of time or if the engine is run for short periods, the batteries may not fully charge.
A battery with a low charge will freeze more easily than a battery with a full charge. Pressurized water may also be used for cleaning. The maximum water pressure for cleaning purposes must be less than 275 kPa (40 psi). Use pressurized water in order to soften mud. Clean the core from both sides. Use a degreaser and steam for removal of oil and grease. Clean both sides of the core. Wash the core with detergent and hot water. Thoroughly rinse the core with clean water. After cleaning, start the engine and accelerate the engine to high idle rpm. This will help in the removal of debris and drying of the core. Stop the engine.
Use a light bulb behind the core in order to inspect the core for cleanliness. Repeat the cleaning, if necessary. Inspect the fins for damage. Bent fins may be opened with a “comb”.