Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

78 SEBU7901-01 Maintenance Section Fuel System Primary Filter/Water Separator - Drain 4. Open air purge screw (2) for the fuel filter by three full turns. Do not remove the air purge screw. NOTICE Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over discon- nected fuel system component. NOTICE Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again. 5. Crank the engine for 30 seconds. Use a suitable container to catch the fuel while you crank the engine. Allow the starter motor to cool for 2 minutes.

Note: You may use the fuel priming pump (1) (IF EQUIPPED) for the fuel filter instead of cranking the engine. 6. Crank the engine for 30 seconds. Allow the starter motor to cool for 2 minutes. 7. Repeat Step 6 until the engine starts and the engine runs. g00709596 Illustration 42 (1) Element (2) Bowl (3) Drain Note: Failure to tighten all fittings could result in serious fuel leaks. Bowl (2) should be monitored daily for signs of water. If water is present, drain the water from the bowl. 8. After the engine has operated smoothly for 30 seconds, turn the priming valve (3) to the “Open (Run)” position. 1. Open drain (3). The drain is a self-ventilated drain.

Catch the draining water in a suitable container. Dispose of the water properly. Note: Shortened injector life may occur if the priming valve (3) is left in the “Closed (Prime)” position. 2. Close drain (3). 9. Clean any residual fuel from the engine components. NOTICE The water separator is under suction during normal engine operation. Ensure that the drain valve is tight- ened securely to help prevent air from entering the fuel system. i01341997 Fuel System Primary Filter/Water Separator - Drain SMCS Code: 1260-543; 1263-543 i02053433 Fuel System Primary Filter (Water Separator) Element - Replace Fuel leaked or spilled onto hot surfaces or elec- trical components can cause a fire.

To help pre- vent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. SMCS Code: 1260-510-FQ; 1263-510-FQ Water in the fuel can cause the engine to run rough. Water in the fuel may cause a electronic unit injector to fail. If the fuel has been contaminated with water, the element should be changed before the regularly scheduled interval. NOTICE Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.