88 SEBU7901-01 Maintenance Section Water Pump - Inspect Inspect the fuel system for leaks. Look for loose fuel line clamps or for loose fuel line tie-wraps. Note: Refer to the Service Manual or consult your Caterpillar dealer if any repair is needed or any replacement is needed. Inspect the piping for the air inlet system and the elbows for cracks and for loose clamps. Ensure that hoses and tubes are not contacting other hoses, tubes, wiring harnesses, etc. Inspect the alternator belt and the accessory drive belts for cracks, breaks or other damage. Belts for multiple groove pulleys must be replaced as matched sets.
If only one belt is replaced, the belt will carry more load than the belts that are not replaced. The older belts are stretched. The additional load on the new belt could cause the belt to break. Drain the water and the sediment from fuel tanks on a daily basis in order to ensure that only clean fuel enters the fuel system. Inspect the wiring and the wiring harnesses for loose connections and for worn wires or frayed wires. Inspect the ground strap for a good connection and for good condition. Inspect the ECM to the cylinder head ground strap for a good connection and for good condition. Disconnect any battery chargers that are not protected against the current drain of the starting motor.
Check the condition and the electrolyte level of the batteries, unless the engine is equipped with a maintenance free battery. Check the condition of the gauges. Replace any gauges that are cracked. Replace any gauge that can not be calibrated. i01057943 Water Pump - Inspect SMCS Code: 1361-040; 1361 A failed water pump might cause severe engine overheating problems that could result in the following conditions: Cracks in the cylinder head A piston seizure Other potential damage to the engine Visually inspect the water pump for leaks. If any leaking is observed, replace the water pump seal or the water pump assembly. Refer to the Service Manual for the disassembly and assembly procedure.