SEBU7901-01 91 Reference Information Section Engine Ratings Reference Information Section A Rating This rating is used for heavy-duty applications that are operated at rated load and at rated rpm up to 100 percent. This rating is used for engines that operate without interruption of load cycling. Typical applications include the following examples: pipeline pumping and ventilation. Engine Ratings B Rating This rating is used when power and/or rpm are cyclic. The engine should be run at full load. The engine should not exceed 80 percent of the duty cycle. Typical applications include the following examples:
irrigation, operation where normal pump demand is 85 percent of the engine rating, oil pumping/drilling, field mechanical pumping/drilling, and stationary/plant air compressors. i01097462 Engine Rating Conditions SMCS Code: 1000 All engine ratings are based on“SAE J1349”. Ratings relate to the standard conditions of “AS1501”, of “ISO3046/1”, of “DIN6271”, and of “BS5514”. C Rating This rating is used when power and/or rpm are cyclic. The horsepower and the rpm of the engine can be utilized continuously for one hour. This is followed by one hour of operation at the A rating or below the A rating. The engine should be run at full load. The engine should not exceed 50 percent of the duty cycle.
Typical applications include the following examples: agricultural tractors, harvesters and combines, off-highway trucks, fire pumps, blast hole drills, rock curshers, wood chippers with high torque rise, and oil field hoisting. The engine ratings are gross output ratings. Gross Output Ratings The total output capability of the engine that is equipped with standard accessories. Standard accessories include the following components: Oil pumps D Rating This rating is used when rated power is required for periodic overloads. The maximum horsepower and the rpm of the engine can be utilized continuously for a maximum of 30 minutes. This is followed by one hour of operation at the C rating.
The engine should be run at full load. The engine should not exceed 10 percent of the duty cycle. Typical applications include the following examples: offshore cranes, runway snow blowers, water well drills, portable air compressors, and fire pump certification power. Fuel pumps Water pumps Subtract the power that is required to drive auxiliary components from the gross output. This will produce the net power that is available for the external load (flywheel). i00819749 Engine Rating Definitions E Rating This rating is used when rated power is required for a short time for initial starting or for sudden overload.
The rating is also used for emergency service when standard power is not available. The horsepower and the rpm of the engine can be utilized continuously for a maximum of 15 minutes. This is followed by one hour of operation at the C rating or by the duration of the emergency. The engine should be run at full load. The engine should not exceed 5 percent of the duty cycle. Typical applications include the following examples: standby centrifugal water pumps, oil field well servicing, crash trucks, portable air compressors, and gas turbine starting motors. SMCS Code: 1000 It is important to know the use of the engine so that the rating will match the operating profile.
The proper rating selection is also important so that the customer’s perception of price and value is realized. In selecting a rating for a specific application, the most important consideration is the time that is spent at full throttle. These rating definitions identify the percent of time at full throttle. The definitions also identify the corresponding times below rated rpm. NOTICE Operating engines above the rating definitions can re- sult in shorter service life before overhaul. Note: The examples of the applications are only for reference. For an exact determination of the appropriate rating, follow the OEM specifications or consult your Caterpillar dealer.