OM3023 10/00 Operation - Section 3 Operating Instructions Page 3-15 OPERATOR CAB AND CONTROLS FIGURE 3-1. STEERING WHEEL AND CONTROLS 1. Steering Wheel 2. Tilt Lever 3. Turn Signals and Headlight Switch 4. Air Horn 5. Windshield Wiper/Washer Switch 6. Headlight Dimmer Switch 7. Retard Control Lever 8. Brake Pedal 9. Throttle Pedal 10. Center Console 11. Differential Lock Pedal (Optional) 12. Hoist Control Lever (1) Steering Wheel And Controls The steering wheel (1, Figure 3-1) may be adjusted through a tilt angle to provide a comfortable position for the operator. (4) Horn The horn (4) is actuated by the horn button in the center of the steering wheel.
When the button is depressed, it activates the horn solenoid. (2) Tilt Lever Adjust the tilt angle of the steering wheel by pulling Tilt Lever (2) up, toward steer- ing wheel and moving the wheel to the desired angle. The steering wheel may also be adjusted (tele- scoped) "In" or "Out" at this time. Pushing the lever back locks the wheel in the desired position. (5) Windshield Wiper / Washer Switch Windshield Wiper Switch (5) is used to activate the wiper blades and washer system. This switch has four wiper position settings and a washer push-button: INT: Wipers operate intermittently. OFF: Wipers are off. LOW: Wipers operate at low speed.HI:Wipers operate at high speed.
(3) Turn Signal Lever Switch Turn Signal Lever (3) is used to activate turn signal lights: Move lever upward to signal a turn to the right (R). Move lever downward to signal a turn to the left (L). Press end of switch to spray washer liquid onto wind- shield.