172 Chapter 14 from the vehicle by a certified service center and shipped to a recycling and reuse company. Once there the batteries are evaluated and undergo initial testing to determine their capacity, voltage, and operating performance level. At this point the batteries can begin the recycling process by being disassembled. The various components are then separated into the different recycling value streams (plastics, metals, etc.).
At this point modules that are built with cells that have been mechanically installed with bolts can be disassembled and the cells can begin undergoing characterization testing; modules that are built by welding the cells together will also undergo characterization testing. Any cells or modules that do not meet minimum performance criteria are then sent to be recycled, while those that do meet the criteria are then grouped within different capacity ranges and are ready for reinstallation and to begin their second life in a new application.
Perhaps one of the most important things to keep in mind when it comes to repurposing and reusing lithium-ion battery cells or modules is the need to characterize them. As was previ- ously mentioned, when building battery packs the overall power and capacity will be limited by the lowest capacity cell in the pack. Similarly, when re-assembling packs with previously used cells or modules, the final pack will be limited by the lowest capacity cell, therefore the cells or modules must be closely matched in capacity and voltage. The other aspect of this is matching cells or modules based on some aging criteria.
In the same way that a lower capacity cell will lower the final capacity of a pack, an “older” or more aged cell or module will limit the life of the newly built pack. So when evaluating cells and modules for second life applica- tions, it is vital to ensure that they are matched not only on the basis of capacity but also based on their state of health (SOH), or in other words how close they are to their end of life. This also applies to servicing of battery packs; you do not want to install a cell or module that is already at 70% of its original SOH into a pack that is near the beginning of its SOH.
For instance, if you installed a module that was at 70% of its SOH into a battery pack that was near 90% of its SOH, the aged battery module would likely fail first thereby damaging the remaining modules or at the very least reducing their SOH. So when building or rebuilding modules you want to very closely match both the current capacity as well as the SOH of the cells and modules. Perhaps the two biggest challenges that second life batteries face today are the supply of batteries for refurbishment and the cost of refurbishing them.
With electric vehicles still making only a small portion of the current vehicles that are on the road and only a very small percentage of the annual sales, there simply are not enough vehicles on the road to generate an ample supply of batteries that can be refurbished. And since the actual life of these batter- ies is still somewhat of a mystery as the first of these vehicles that were sold into the market have not yet reached the end of their estimated life, we really will not know until they get there how many will begin coming into the recycling market. As I sit here writing this, it is 2014 only four years after the introduction of the Chevrolet Volt and the Nissan Leaf, which