D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 5) Reassembly z Replace all the seal rings with new ones. z After removing carbon deposit, submerge the nozzle in diesel oil and clean it. z Assemble the parts and tighten them to specified torque. 6) Adjustment z After reassembly, install the nozzle on a tester. z With the adjusting screw loosened, operate the nozzle 2 3 times to z Operate the nozzle tester lever at bleed it. the specified rate. z Adjust the injection pressure to the standard pressure by spring tension shims. z After adjusting the injection pressure, tighten the cap nut to specified torque. z Re-check the injection pressure and see if the spray pattern is normal.
Spray pattern should be uniform and free of spattering. Abnormal Normal Abnormal 7) Testing With the nozzle assembled to a nozzle tester and specified pressure applied, check the nozzle for fuel leakage. 119 Printed in Jan. 2001 PS-MMA0415-E1A Engine Model D1146 D1146TI DE08TIS Opening pressure 210 kg/cm2 214 kg/cm2 1st : 160 kg/cm2 2nd : 220 kg/cm2