D1146/D1146TI/DE08TIS MAINTENANCE MANUAL (2) Inspection of cylinder head 1) Check for the cylinder head. z Remove carbon from the cylinder head lower surface, and then should be careful not to scratch the surface. z Check any crack or damage that can not found by naked eyes through the hydraulic or magnetic particle test. 2) Distortion of lower surface z As shown in figure, measure the M1067 cylinder head's distortion at 6 directions with horizontal ruler and clearance z If the measured value is beyond the gauge. limit value, correct it by means of the fine grinding paper or grinding machine. z If it is beyond the max.
allowable value, replace the cylinder head Lower face warpage and height G1093 3) Flatness Check the flatness of the installing surface of cylinder head's intake and exhaust manifolds with horizontal ruler and clearance gauge. 4) The hydraulic test The hydraulic test of cylinder head is same as the cylinder block test. 49 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit Warpage 0.2 mm or less 0.3 mm Thickness : t (reference) 109.9 ∼ 110.1 mm 108.4 mm Standard Limit 0.05 mm 0.2 mm