Yanmar — 18

2. Product explanation (1) Controls and Equipment Note: The mark ® indicates equipment for type B contro! panel only. Mechanism ‘Controls and Equipment| Key Switch Rotary switch with 2 positions, In the OFF position, the switch key can be inserted or removed. In OFF, all electric current is cut off. In ON (1 position to the right), the engine is turned on. In ON, electric current to the controls and equipment is tuned on. The engine cannot be stopped with the key switch. Py a Alarm Lamps When the button is pushed, the engine is started Lamps come on when there is a problem. See Section 2 for the types of lamps and the way they work. Alarm Buzzer Buzzer goes off when there is a problem.

© Illumination Switch This switch turns on the control panel lamps. ® Tachometre The engine's rotation speed is indicated by the needle. | © Hour Metre The number of hours of operation is indicated, and can be used as a guide for periodic | (optional) maintenance checks. The hour meter is at the bottom of the tachometre. Start Button (2) Alarm Equipment (lamps and buzzer) (3) Alarm Devices Mechanism When the sensor detects a problem during the that Check instrument panel operation, when the starter key is turned on: the lamps come on and the the on lamps pilot below are as shown buzzer goes off.

Control Panel (Type A) There are 4 separate alarm monitors the upper left side of the control panel. Control Panel (Type B) on Alarm monitors are located on the upper right side of the control panel. 18 lamps Lit Charge lamp Lit Cooling water temp. alarm lamp Off Under normal conditions, the monitors are off. When there is a problem, the monitors light up. Pilot Low L.O. pressure alarm lamp NOTE: All these signals will continue until the engine starts up or the key is turned off.