5. Trouble and Troubleshooting E 'Note: Other warning lamps do not go on when the switch Is turned on. They only go on wh en there is an abnorma li ty. 45 Trouble Alarm Buzzer and Alarm Lamps On During Opera lion Eng.Lube Oil Press. Warning Lamp goes on Probable Cause Measure Reference "l• ffil r -l.':l Shift to low speed operation immediately, and check which lamp has come on. Stop the engine for inspection. If no abnormality is identified and there is no problem with operation, return to port at your lowest speed and request repairs. Engine Lube Oil insufficient: Fuel filter clogged. Check Lube Oil level. Replenish or replace.
3.2.2 4.3.1(1) ·water proof warning lamp goes on Breakage of seal mount on the sail drive. Check and change the rubber mount. C.W.Temp.(Fresh Water) warning lamp goes on Insufficient water In fresh water cooler Insufficient seawater causing temp. to rise. Contamination Inside cooling system. Check cooling water and replenish. Check seawater system. Ask for repairs. 3.2.4 Faulty Warning Devices ,,, el ~ Do not operate the engine if alarm devices are not repaired. Serious accidents may result if difficulties are not spotted due to faulty alarm lamps. When switch is turned ON: Alarm buzzer does not sound. Circuit broken or buzzer defective. Ask for repairs. Warning lamps do not go on Eng.
Lube Oil Press. Seawater. No current available. Circuit broken or lamp burnt out. Ask for repairs. One of the warn1ng lamps does not go out Sensor switches faulty. Ask for repairs. Charge lamp does not go out during operation V·belt Is loose or broken. Bat:lery defective. Alternator power generator failure. Replace V-belt; adjust tension. Check fluid level, specific gravity; replace. Ask for repairs. 4.3.4(3) 4.3.2(4) el