05-E2B, 05-E2BG, WSM DIESEL ENGINE Oil Clearance between Crankshaft Journal and Crankshaft Bearing 1 1. Measure the O.D. of the crankshaft front journal with an outside micrometer. 2. Measure the I.D. of the crankshaft bearing 1 with an inside micrometer, and calculate the oil clearance. 3. If the clearance exceeds the allowable limit, replace the crankshaft bearing 1. 4. If the same size bearing is useless because of the crankshaft journal wear, replace it with an undersize one referring to the table and figure. (Reference) Undersize dimensions of crankshaft journal W10337170 Replacing Crankshaft Bearing 1 (When removing) 1.
Press out the used crankshaft bearing 1 using a crankshaft bearing 1 replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1. Clean a new crankshaft bearing 1 and crankshaft journal bore, and apply engine oil to them. 2. Using a crankshaft bearing 1 replacing tool, press in a new bearing 1 (2) so that its seam (1) directs toward the exhaust manifold side. (See figure.) (1) Seam (2) Crankshaft Bearing 1 (3) Cylinder Block (A) Dimension W10339460 S-60 KiSC issued 06, 2011 A Oil clearance between crankshaft journal and crankshaft bearing 1 Factory spec. 0.034 to 0.114 mm 0.0013 to 0.0045 in. Allowable limit 0.20 mm 0.0079 in. Crankshaft journal O.D. Factory spec.
47.934 to 47.950 mm 1.8872 to 1.8878 in. Crankshaft bearing 1 I.D. Factory spec. 47.984 to 48.048 mm 1.8891 to 1.8916 in. Undersize 0.2 mm 0.008 in. 0.4 mm 0.016 in. Dimension A 2.3 to 2.7 mm radius 0.0906 to 0.1063 in. radius 2.3 to 2.7 mm radius 0.0906 to 0.1063 in. radius *Dimension B 1.0 to 1.5 mm relief 0.0394 to 0.0591 in. relief 1.0 to 1.5 mm relief 0.0394 to 0.0591 in. relief Dimension C 47.734 to 47.750 mm dia. 1.8793 to 1.8799 in. dia. 47.534 to 47.550 mm dia. 1.8714 to 1.8720 in. dia. (0.8-S) The crankshaft journal must be fine-finished to higher than ∇∇∇∇ *Holes to be de-burred and edges rounded with 1.0 to 1.5 mm (0.0394 to 0.0591 in.) relief. Dimension (A) Factory spec.
0 to 0.3 mm 0 to 0.0118 in.