Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE (8) Alternator Bearing 1. Check the bearing for smooth rotation. 2. If it does not rotate smoothly, replace it. W1019790 Stator 1. Measure the resistance across each lead of the stator coil with resistance range of circuit tester. 2. If the measurement is not within factory specification, replace it. 3. Check the continuity across each stator coil lead and core with resistance range of circuit tester. 4. If infinity is not indicated, replace it. W1019964 Rotor 1. Measure the resistance across the slip rings. 2. If the resistance is not the factory specification, replace it. 3.

Check the continuity across the slip ring and core with resistance range of circuit tester. 4. If infinity is not indicated, replace it. W1020094 Slip Ring 1. Check the slip ring for score. 2. If scored, correct with an emery paper or on a lathe. 3. Measure the O.D. of slip ring with vernier calipers. 4. If the measurement is less than the allowable limit, replace it. Brush Wear 1. Measure the brush length with vernier calipers. 2. If the measurement is less than allowable limit, replace it. 3. Make sure that the brush moves smoothly. 4. If the brush is defective, replace it. W1020208 W1020329 S-68 KiSC issued 06, 2011 A Resistance Factory spec. Less than 1.0 Ω Resistance Factory spec.

2.9 Ω Slip ring O.D. Factory spec. 14.4 mm 0.567 in. Allowable limit 14.0 mm 0.551 in. Brush length Factory spec. 10.0 mm 0.3937 in. Allowable limit 8.4 mm 0.331 in.