05-E2B, 05-E2BG, WSM G GENERAL [2] CHECK POINTS OF INITIAL 50 HOURS Changing Engine Oil CAUTION Be sure to stop engine before changing engine oil. 1. Start and warm up the engine for approx. 5 minutes. 2. Place an oil pan underneath the engine. 3. To drain the used oil, remove the drain plug (1) at the bottom of the engine and drain the oil completely. 4. Screw the drain plug (1). 5. Fill new oil up to upper line on the dipstick. IMPORTANT Q When using an oil of different maker or viscosity from the previous one, remove all of the old oil. Never mix two different types of oil. Engine oil should have properties of API classification CD/ CE/CF/CF-4/CG-4.
Use the proper SAE Engine Oil according to ambient temperature. Upon an oil change, be sure to replace the gasket with new one.
(1) Drain Plug W1016604 G-8 KiSC issued 06, 2011 A Above 25 °C (77 °F) SAE 30 or SAE 10W-30 SAE 10W-40 0 °C to 25 °C (32 °F to 77 °F) SAE 20 or SAE 10W-30 SAE 10W-40 Below 0 °C (32 °F) SAE 10W or SAE 10W-30 SAE 10W-40 Oil pan depth Models Capacity 125 mm (4.92 in.) 130 mm (5.12 in.) D905-E2B / E2BG D1005-E2B /E2BG D1105-E2B /E2BG D1105-T-E2B 5.1 L 1.35 U.S.gals – V1305-E2B V1505-E2B 6.0 L 1.59 U.S.gals – V1305-E2BG V1505-E2BG – 6.7 L 1.77 U.S.gals V1505-T-E2B – 6.7 L 1.77 U.S.gals Tightening torque Drain plug with copper gasket M12 × 1.25 32.4 to 37.3 N·m 3.3 to 3.8 kgf·m 23.9 to 27.5 ft-lbs M22 × 1.5 63.7 to 73.5 N·m 6.5 to 7.5 kgf·m 47.0 to 54.2 ft-lbs Drain plug with rubber coated gasket M22 × 1.5 44.1 to 53.9 N·m 4.5 to 5.5 kgf·m 32.5 to 39.8 ft-lbs