05-E2B, 05-E2BG, WSM G GENERAL Changing Radiator Coolant (L.L.C.) (Continued) (Anti-freeze) There are two types of anti-freeze available: use the permanent type (PT) for this engine. Before adding anti-freeze for the first time, clean the radiator interior by pouring fresh, soft water and draining it a few times. The procedure for mixing water and anti-freeze differs according to the make of the anti-freeze and the ambient temperature. Basically, it should be referred to SAE J1034 standard, more specifically also to SAE J814c. Mix the anti-freeze with fresh, soft water, and then fill into the radiator.
IMPORTANT Q When the anti-freeze is mixed with fresh, soft water, the anti- freeze mixing ratio must be less than 50 %. * At 1.013 Ч 100000 Pa (760 mmHg) pressure (atmospheric). A higher boiling point is obtained by using a radiator pressure cap which permits the development of pressure within the cooling system. NOTE Q The above data represents industrial standards that necessitate a minimum glycol content in the concentrated anti-freeze. When the coolant level drops due to evaporation, add fresh, soft water only to keep the anti-freeze mixing ratio less than 50 %. In case of leakage, add anti-freeze and fresh, soft water in the specified mixing ratio. Anti-freeze absorbs moisture.
Keep unused anti-freeze in a tightly sealed container. Do not use radiator cleaning agents when anti-freeze has been added to the coolant. (Anti-freeze contains an anti-corrosive agent, which will react with the radiator cleaning agent forming sludge which will affect the engine parts.) W1024852 G-27 KiSC issued 06, 2011 A Vol % anti-freeze Freezing point Boiling point* °C °F °C °F 40 –24 –11.2 106 222.8 50 –37 –34.6 108 226.4