Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE 4. CHECKING, DISASSEMBLING AND SERVICING [1] CHECKING AND ADJUSTING (1) Engine Body Compression Pressure 1. Run the engine until it is warmed up. 2. Stop the engine. 3. Remove the air cleaner, the muffler and all glow plugs (or nozzles). 4. Set a compression tester with the adaptor to the glow plug hole (or nozzle hole). Nozzle hole : Adaptor H (07909-31231) Glow plug hole : Adaptor L (07909-31301) 5. After making sure that the stop lever is set at the stop position (non-injection), run the engine with the starter and measure the compression pressure. 6. Repeat steps 4 and 5 for each cylinder. 7.

If the measurement is below the allowable limit, apply a small amount of oil to the cylinder wall through the glow plug hole (or nozzle hole) and measure the compression pressure again. 8. If the compression pressure is still less than the allowable limit, check the top clearance, valve clearance and cylinder head. 9. If the compression pressure increases after applying oil, check the cylinder wall and piston rings. NOTE Q Check the compression pressure with the specified valve clearance. Always use a fully charged battery for performing this test. Variances in cylinder compression values should be under 10 %.

W10178940 S-15 KiSC issued 06, 2011 A Compression pressure D905-E2B / E2BG D1005-E2B / E2BG D1105-E2B / E2BG V1305-E2B / E2BG V1505-E2B / E2BG Factory spec. 3.72 to 4.12 MPa 38 to 42 kgf/cm2 539 to 596 psi Allowable limit 2.25 MPa 23.0 kgf/cm2 327 psi D1105-T-E2B V1505-T-E2B Factory spec. 3.14 to 3.53 MPa 32 to 36 kgf/cm2 454 to 511 psi Allowable limit 2.25 MPa 23.0 kgf/cm2 327 psi