Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Nozzle Holder 1. Secure the nozzle retaining nut (7) with a vise. 2. Remove the nozzle holder (1), and take out parts inside. (When reassembling) Assemble the nozzle in clean fuel oil. Install the push rod (4), noting its direction. After assembling the nozzle, be sure to adjust the fuel injection pressure. (1) Nozzle Holder (2) Adjusting Washer (3) Nozzle Spring (4) Push Rod (5) Distance Piece (6) Nozzle Piece (7) Nozzle Retaining Nut (5) Electrical System W1018491 CAUTION To avoid accidental short circuit, be sure to attach the positive cable to the positive terminal before the negative cable is attached to the negative terminal.

Never remove the battery cap while the engine is running. Keep electrolyte away from eyes, hands and clothes. If you are spattered with it, wash it away completely with water immediately. Keep open sparks and flames away from the battery at all times. Hydrogen gas mixed with oxygen becomes very explosive. IMPORTANT Q If the machine is to be operated for a short time without battery (using a slave battery for starting), use additional current (lights) while engine is running and insulate terminal of battery. If this advice is disregarded, damage to alternator and regulator may result. Battery Voltage 1. Stop the engine. 2.

Measure the voltage with a circuit tester between the battery terminals. 3. If the battery voltage is less than the factory specification, check the battery specific gravity and recharge the battery. (1) Positive Terminal (2) Negative Terminal W10125620 S-22 KiSC issued 06, 2011 A Tightening torque Nozzle holder 34.3 to 39.2 N·m 3.5 to 4.0 kgf·m 25.3 to 28.9 ft-lbs Overflow pipe retaining nut 19.6 to 24.5 N·m 2.0 to 2.5 kgf·m 14.5 to 18.1 ft-lbs Nozzle holder assembly 49.0 to 68.6 N·m 5.0 to 7.0 kgf·m 36.2 to 50.6 ft-lbs Battery voltage Factory spec. More than 12 V