05-E2B, 05-E2BG, WSM DIESEL ENGINE (5) Piston and Connecting Rod Oil Pan and Oil Strainer 1. Remove the oil pan mounting screws (5). 2. Remove the oil pan (4). 3. Remove the oil strainer (3). (When reassembling) After cleaning the oil strainer, check to see that the filter mesh in clean, and install it. Visually check the O-ring (1), apply engine oil, and install it. Securely fit the O-ring to the oil strainer. To avoid uneven tightening, tighten oil pan mounting screws in diagonal order form the center. IMPORTANT Q Scrape off the old adhesive completely. Wipe the sealing surface clean using waste cloth soaked with gasoline.
Now apply new adhesive 3 to 5 mm (0.12 to 0.20 in.) thick all over the contact surface. Apply the adhesive also on the center of the flange as well as on the inner wall of each screw hole. Cut the nozzle of the “liquid gasket” container at its second notch. Apply “liquid gasket” about 5 mm (0.20 in.) thick. Within 20 minutes after the application of fluid sealant, reassemble the components. Wait then for about 30 minutes, and pour oil in the crankcase. (1) O-ring (2) Screw (3) Oil Strainer (4) Oil Pan (5) Oil Pan Mounting Screw W10236610 Connecting Rod 1. Remove the connecting rod cap. (When reassembling) Align the marks (a) with each other.
(Face the marks toward the injection pump.) Apply engine oil to the connecting rod screws and lightly screw it in by hand, then tighten it to the specified torque. If the connecting rod screw won’t be screwed in smoothly, clean the threads. If the connecting rod screw is still hard to screw in, replace it. (a) Mark W10242740 S-37 KiSC issued 06, 2011 A Tightening torque Connecting rod screw 41.2 to 46.1 N·m 4.2 to 4.7 kgf·m 30.4 to 34.0 ft-lbs