05-E2B, 05-E2BG, WSM DIESEL ENGINE (6) Flywheel and Crankshaft Flywheel 1. Secure the flywheel to keep it from turning, using a flywheel stopper. 2. Remove all flywheel screws (1) and then remove the flywheel (2). (When reassembling) Align the mark (a) on the outer surface of the flywheel horizontally with the alignment mark (b) on the rear end plate. Now fit the flywheel in position. Apply engine oil to the threads and the undercut surface of the flywheel screw and fit the screw. (1) Flywheel Screw (2) Flywheel (a) 1TC Mark (b) Alignment Mark W10290240 Bearing Case Cover 1. Remove the bearing case cover mounting screws. 2. Remove the bearing case cover (6).
(When reassembling) Fit the bearing case gasket (3) and the bearing case cover gasket (4) with correct directions. Install the bearing case cover (6) to position the casting mark on it upward. Apply engine oil to the oil seal (5) lip and take care that it is not rolled when installing. Tighten the bearing case cover mounting screws with even force on the diagonal line.
(1) Bearing Case Cover Mounting Screw (Inside) (2) Bearing Case Cover Mounting Screw (Outside) (3) Bearing Case Gasket (4) Bearing Case Cover Gasket (5) Oil Seal (6) Bearing Case Cover (a) Top Mark “UP” (b) Upside W10292140 S-40 KiSC issued 06, 2011 A Tightening torque Flywheel screw 53.9 to 58.8 N·m 5.5 to 6.0 kgf·m 39.8 to 43.4 ft-lbs Tightening torque Bearing case cover mounting screw 9.8 to 11.3 N·m 1.00 to 1.15 kgf·m 7.2 to 8.3 ft-lbs