05-E2B, 05-E2BG, WSM DIESEL ENGINE [3] SERVICING (1) Cylinder Head and Valves Top Clearance 1. Remove the cylinder head. 2. With the piston at TDC, use grease to affix three or four plastigauges of a diameter 1.5 mm (0.059 in.) x 5.0 to 7.0 mm (0.20 to 0.27 in.) long to the crown of the piston; keep the gauges away from the intake valve and combustion chamber fittings. 3. Take the piston to an intermediate position, install the cylinder head and tighten the head bolts to the specified torque. 4. Turn the crankshaft so the piston goes through TDC. 5. Remove the cylinder head and compare the width of the crushed plastigages with the scale. 6.
If they are out of spec, check the oil clearance of the crank pin, journals and piston pin. NOTE Q Top clearance = Width of the crushed plastigauge. (1) Plastigauge (2) Scale W1020190 Cylinder Head Surface Flatness 1. Clean the cylinder head surface. 2. Place a straightedge on the cylinder head’s four sides and two diagonal as shown in the figure. 3. Measure the clearance with a thickness gauge. 4. If the measurement exceeds the allowable limit, correct it with a surface grinder. IMPORTANT Q Do not place the straightedge on the combustion chamber. Be sure to check the valve recessing after correcting. W1027737 S-45 KiSC issued 06, 2011 A Top clearance Factory spec.
0.55 to 0.70 mm 0.0217 to 0.0276 in. Tightening torque Cylinder head screws 63.7 to 68.6 N·m 6.5 to 7.0 kgf·m 47.0 to 50.6 ft-lbs Cylinder head surface flatness Allowable limit 0.05 mm 0.0020 in.