27 OPERATION OF THE ENGINE CHECK POINTS AFTER STARTING THE ENGINE After starting the engine, but before starting operation, check the following points: 1. Put the throttle potentiometer in the middle between " " and " " symbols and let the engine idle for approx. five minutes. This allows the engine lubricant to warm up and penetrate every part of the engine. B Engine Stop Button To avoid personal injury: A Keep hands away from rotating parts. A Be sure to return the stop button to former position after the engine stops. 2. Once the engine has warmed up, check: A the warning lamp "Engine oil pressure" has gone out. A the warning lamp "Battery charge" goes out when engine speed is increased.
A the color of the exhaust is normal and no abnormal noises or vibrations are heard or felt. A no fluid is leaking from pipes or hoses. The engine stops when the starter key is turned off. If the engine does not stop, pull the stop button to stop the engine. C Should any following conditions occur, stop the engine immediately. A The engine rpm's increases or decreases suddenly. A Sudden abnormal noises are heard. A Exhaust is black. A Warning lamp for engine oil lights up during operation. A In these cases, the excavator must be checked and serviced by your local the KUBOTA dealer.
STOPPING THE ENGINE (1) Stop button (2) Starter key B Precautions in case of Overheat To avoid personal injury or death: A Do not keep the bucket or dozer in an elevated position, as a person could accidentally touch the levers and cause serious accidents. To avoid personal injury: A Do not open the radiator cap during operation or just after shut-down. Otherwise, steam or very hot coolant may gush out, getting you scalded. Make sure the radiator has cooled down enough before opening its cap. 1. Place the bucket and dozer on the ground. 2. After slowing the engine to idle, turn the key to "STOP".
If by any chance the coolant temperature rises close to or above the boiling point ( "H" on the water temperature gauge) (overheat condition), take the following steps. 1. Stop operating the machine. (Relieve the engine of any load.) 2. Do not shut off the engine suddenly. Before shutting off the engine, keep it idling under no load for about 5 minutes. 3. Stay away from the engine or overflow for 10 minutes or until the steam overflow stops. 4. Be sure that there is no danger of getting scalded. Pinpoint and remove the cause of overheat, referring to the "TROUBLESHOOTING" section. Once the issue is resolved, the engine may be restarted. 3. Remove the key. 4.
Pull the lock lever to "LOCK" position.