Kubota — Important Information on Excavator Operation

47 EXCAVATOR OPERATION AUTO IDLE (AI) OPERATION 1. Throttle Potentiometer With this potentiometer the operator can adjust the engine speed when the Auto Idle control is activated. 2. Switch for Auto Idle (AI) Control With this switch the Auto Idle control is turned on or off. The Auto Idle control allows the engine speed to drop to idle speed when the control levers are left in neutral for longer than four seconds. If the control is activated, the engine speed rises immediately to the preset rpm. If the Auto Idle is not activated the throttle potentiometer can be utilized to control engine speed in a similar way to a conventional throttle control lever.

IMPORTANT INFORMATION ON EXCAVATOR OPERATION A Do not try to crush concrete or boulders using side swings with the bucket. Also avoid using side sweeps of the bucket to move earth piles. A Under all circumstances avoid the following operations: A Excavation using the gravitational impact of the machine. A Compacting of gravel or soil using the dropping action of the bucket. A Excavation using the traveling power of the machine. A Do not try to drop or shake off soil adhering to the bucket in the manner given in the points below. This can cause damage to the machine.

Adhering soil can be shaken off when the bucket is being emptied by moving the bucket out to the maximum stroke of the cylinder. Should this not suffice, swing out the arm as far as possible and operate the bucket back and forth. A Do not hit the dozer with the boom cylinder! Make sure that the boom cylinder does not hit the dozer when doing deep excavation. If necessary swing around so that the dozer is in the back of the machine. A Pay attention when pulling in the bucket! When pulling in the bucket (for driving or transportation) avoid hitting the dozer. A Avoid collisions! When moving the excavator, pay attention that the dozer does not collide with obstructions such as boulders, etc.

Such collisions shorten the life of the dozer and the cylinder substantially. A Support the machine correctly! When stabilizing the machine with the dozer, lower the dozer to engage the full width on the ground. A If the water or mud level reaches higher than the top of the tracks, the swivel bearing, swivel motor gear and ring gear may be exposed to mud, water and other foreign objects. The excavator must be properly pressure washed after each use. A Thoroughly clean the area around the swivel bearing, swivel motor gear and ring gear to remove foreign objects. A Inspect the swivel motor oil sump (if equipped) for water contamination.

If water is present, refer to operator's manual for lubricant replacement procedure. A Refer to operator's manual for proper swivel bearing, swivel motor gear and ring gear lubrication procedures. A Reinstall any protective covering if removed earlier. (1) Throttle potentiometer (2) Switch for Auto Idle control (3) Lamp for Auto Idle control A It is possible that the Auto Idle may not function until hydraulic oil warms up in the cold weather. Therefore it is not recommended that the Auto Idle be activated until the machine is completely warmed up. A Before operating the control lever, check the Auto Idle Indicator Lamp.

A When operating in confined spaces or when loading onto a vehicle, turn the Auto Idle switch off (Light off). This is to prevent unwanted engine speed increases when control levers are activated. A The Auto Idle control, when selected by a switch, provides the operator with a way to control engine speed without moving the Throttle Potentiometer, simply by not activating any control levers for about four seconds after stopping work, and then to simply restore a preset (by potentiometer) engine speed by activating any control lever to return to work. A The purpose of the system is to reduce fuel consumption, noise and operator fatigue.

A When the dozer control lever is locked at the "Float" position on the angle blade type, the Auto Idle function is not activated even if any other control lever is set in the neutral position.