. OPERATION OPERATION CHECK WATER SEPARATOR, DRAIN WATER AND SEDIMENT NOTICE NOTICE 3 - 72 Do not mo ve the blade when the fron t cover and engine side cove r on the left s ide of the machine are o pen. The blade will hit the covers an d there is danger that the c . Open up the engine side cov er on the left side of the m achine. Th e water separator form s one unit with fuel pre-filt er (1). . I t is possible to check fo r water and sediment through r or sediment are accumulated, lts of the front cover at the front of hrough transparent cap (2). If wate drain the water as follows.
1) Remove the mounting bo the machine, then remov 2) Pull out drain hose (3) to a container under the ho 3) Loosen drain valve (4) a accumulated in transpar 4) Check that the fuel com tighten drain valve (4) se 5) Return the drain hose (3 6) Use the mounting bolts t ransparent cap (2). If wate drain 1) R the water as follows. emove the mounting bo e machine, then remov ull out drain hose (3) to e the front cover. the front of the machine and set container under the ho oosen drain valve (4) a ccumulated in transpar se to catch the drained water. nd drain the water and sediment ent cap (2). es out from drain hose (3), then curely. ) to its original position. o install the front cover.
4) C heck that the fuel com ghten drain valve (4) se 5) R eturn the drain hose (3 6) U se the mounting bolts t If t he wate r inside transparent cap (2 ) freezes, check that the froze n water has melted completely, then use the procedure above to drain th REMARK If transparent cap (2) is dirty a nd it is difficult to check th e condition , clean transparent ca p (2) or replace it when replac ing the fuel prefilter car tridge (1). When cleaning, if drain valve ( 4) has been removed, coa t the O-ring with grease, then tig hten until it contacts the bottom .