Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUSTMENT ADJUST OPERATOR'S SEAT WARNING adjust the weight seat to a harder adjustment to a position which is adjusting. If your may suddenly 3 - 78 When adjusting the position of the operator's seat, alwa ys set the work equipment lock lev er to the LOCK positi on to preven t any accidental contact with the control levers. Always adjust the operator's seat before starti ng each operation or when the operators change shift.

When adjustin g the seat, put your back agains t the backrest and adjust to a p osition where the b rake peda l can be fully depre (A) Fore-and-aft Pull lever (1), set the seat to a position where it is then release the Fore-aft adjustm (B) Weight adjus Turn knob (2) un der the seat to match the weight with your own w eight. The weight can be adjusted to 50 to 120 kg (110 REMARK When setting the seat to a softer setting, a adjustment to a lighter setting. When setting the adjustment to a setting, adjust th e weight adjustment to a heavie Before traveling harder setting th (C) Adjust reclini Pull up lever (3 comfortable for o peration, then release the lever.

Sit with your ba ck against the seat back when back is not touc move forward. REMARK The seat can be reclined more when the seat is p ushed to the front. The amount of reclining decrea ses as the seat is pushed back, so when moving the seat back, r eturn the seatback to the uprig ht position.

(D) Seat angle a Front angle ad To raise the fron t of the seat, apply your weight t o the seatback, while pulling up To lower the fron t of the seat, apply your weight t o the front of the seat, while pu Rear angle ad justment of seat (5 stages) To raise the rear of the seat, stand up on your fe et a little, while pulling up lever To lower the rea r of the seat, apply your weight t o the rear of the seat, while pull