. OPERATION OPERATION STARTING IN COLD WEATHER (Ambient temperature below 10 ° C (50 ° F)) 3 - 91 NOTICE Do not carry out operations or operate the levers suddenly when the hydraulic oil is at low temperat ure. Always carry out the warming-up operation. This will also extend t Do not suddenly accelerate the e he service life of the machine. ngine before the warming-up operation is completed. Do not run the engine under no l than 20 minutes. This will have oad at low idling or high idling for more an adverse effect on the environment, and it will also have an adverse effect on the turbocharger and internal components of the engine.
If it is necessary to run at idling, apply a load from time to time, or run the eng ine at a mid-speed. 1. Set fuel control dial (1) to a position (MIN) and full sp engine at a mid-range spe minutes (warming-up opera point midway between low idling eed position (MAX), and run the ed under no load for approx. 10 tion). 2. Operate blade control lever (2) to the RAISE position to raise the blade to the maximum h in turn to the left tilt relief minutes in turn. 3.
In addition, operate blade c eight, then operate the lever slowly and right tilt relief positions for 5 ontrol lever (2) fully to the RAISE position, hold it there and op right tilt relief positions, the position to lower the blade to lever fully to the FLOAT po intermittently to the left and for 5 minutes. erate it intermittently to the left and n operate the lever to the LOWER the ground. After this, operate the sition, hold it there and operate it right tilt positions in turn repeatedly