Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUST ANGLE OF BLADE EDGE WARNING The standard cutting angle (a) is 57 ° and the standard distance between the joints is 368.5 mm (14.5 in). This is suitable for general operations. In suitable and is make make standard 3 - 106 ADJUSTING POSTURE OF WORK EQUIPMEN T For details of the proced ure for adjusting play in the center ball, see t he "ADJUST PLAY IN CENTER BALL (PAGE 4-44)" in the MAINTENA NCE Section and WHEN REQUI RED Section. It is dangerous if the work equipment moves by accident when then angle of the blade edge is bei ng adjusted.

Set the work equipment in a stable positio n, lower the blade completely to the g round, stop the engine, then set then work equipment lock lever securely to the LOCK positi on. It is possible to change th e cutting angle of the blade (a) to match th e soil condition and the nature of the operation To increase cutting angl e (a), rotate rod (1) to increase di stance (L) To reduce cutting angle (a), rotate rod (1) to reduce dista The maximum cutting an gle (a) is 59.5° and the distance the joints is 408.5 mm (1 6.1 in).

ng operations on clay soil or har This is suitable for diggi addition, this will improve the removal of the soil from the bl reduce spillage of soil ov er the back of the blade. This is also for dozing operation s on slopes. The minimum cutting an gle (a) is 54.5° and the distance the joints is 327.5 mm (1 2.9 in). This allows the blade t suitable for hauling oper o gather a larger amount of soi ations on soft soil. In addition, it easier for the cutting edg e of the blade to dig into the soil Method of adjusting hen remove cover (3). A) of rod (1) and turn rod (1). 1. Remove 2 bolts (2), t 2. Insert a bar in hole ( 3. When increasing dist cover (3) is at its or distance (L) any long 4.

When reducing dista thread of rods (4) a distance (L) any sho 5. When setting distanc length, as a guideline rods (4) and (5) can 6. After completing adju to its original position 1. Remove 2 bolts (2), t 2. Insert a bar in hole ( 3. When increasing dist ance (L) between the joints, incre iginal mounting distance. Do n er than this. nce (L) between the joints, reduce nd (5) contacts rod (1). Do n rter than this. e (L) between the joints to the s 5. When setting distanc , set to a position where small ho be seen slightly from rod (1). 6. After completing adju stment, use 2 bolts (2) to install c .