Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 115 Since loading and unloading of th e machine is dangerous, be extremely c areful. When loading or unloading the ma chine, operate it slowly with the engine speed low and the transmission in the 1 Use ramps having sufficient width , length, thickness, and strength. Install them securely and set their angle to 15° If the ramps are deflected apprecia Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance b etween the shoulder of th e road and the trailer. age of the machine so that the machine will not slip sideways on the ramps. In addition, il, etc. from the ramps.

Remove mud from the undercarri age of the machine so that the machin remove water, snow, ice, grease, o Never steer the machine on the ra mps, since steering on the ramps can c ause the mach ine to tip over. If it is ne cessary to change the travel direction, return to the ground or to the bed of the traile r, then change t The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero us. Accordingly, pass the border slowly When loading or unloading, alwa ys use ramps or a platform. Procee LOADING WORK l ground only. the edge of a road. 1. 2. 1. Load and unload on firm leve Maintain a safe distance from 2.

Apply the trailer brakes secur ely and put blocks (1) under the tires to hold the trailer in posi tion.Set gap (3) between ramps (2) to match the distance betw een the left and right tracks, and keep angle (4) to a maximum of 15°. If ramps (2) bend appreciably under the weight of the machine, put wooden block (5) under t he ramps to support them. 3. Start the engine. In a cold weather, carry ou t an engine warming-up run, referring to the section, "STARTING IN COLD this manual. FREE position (F). the speed range to 1st or less, d the ramps and drive slowly. machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer.

WEATHER (PAGE 3-91)", in 4. Set parking brake lever to the 5. Use the variable mode to set and travel slowly. Set the travel direction towar 6. 7. The center of gravity of the border between the ramps unbalanced and becomes da border slowly. and trailer, and the machine is 8. Stop the machine at the spec