. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 122 BEFORE STORA GE g-term storage (more than one month), store as follows. When keeping in lon g-term storage (more than one month), store Clean and wash al l parts, then store the machine indoors. If th e machine has to be store d outdoors, s elect level ground and cover the machine with a sheet. cting. ston rods and the idler adjusting rods. Completely fill the fuel tank. This prevents moisture from colle Lubricate and cha nge the oil before storage.
Apply a thin coat o f grease to metal surface of the hydraulic pi ston rods and the idler adjustin Disconnect the neg ative terminals of the battery and cover it or r emove it from the machine and s tore it s eparately. Set all the control levers to the Neutral position or HOLD posi lever to the LOCK position. tion, then set the work equipment lock lever and 30% for the engine coolant. ock lever parking brake lock To prevent rust, fill with COOLANT to give a density of at least 30% for the engine coolant. If it is necessary to perf orm the rust-prevention operation while the machi ne is indoors, open the doors and windows to improve ventilation and prevent gas poisoning.
During storage, op erate and move the machine for a short dista nce once a month so that a new film of o il will coat moving parts. At t he same time, also charge the battery. m the hydraulic cylinder rods. When operating th e work equipment, wipe off all the grease fro m the hydraulic cylinder r If the machine is e quipped with an air conditioner, operate the air conditioner for 3 to 5 minute s once a month to lubricateall parts o check the refrigera f the air conditionercompressor. Always run the engine at low idle when doin g this. I n addition, nt level twice a year.
NOTICE If the machine has bee n stored without carrying out the monthly rust-pr evention operation, consult your K omatsu distributor before using it. When using the mac hine after long-term storage, do as follows b efore using it. Wipe off the greas e from the hydraulic cylinder rods. at all lubrication points. Add oil and grease When the machine is stored for a long period, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine . If there is water in the oil, change all the o il.