. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE END BITS AND CUTTING EDGES WARNING REMARK If the cutting edge and the end bit on both sides are worn out, replace with new ones. If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace. 4. Remove the cutting edge and the end bit and clean the mounting surface. 5. Reverse or replace the cutting edge and the end bit when worn out. 1) Remove nut (1) and bolt (2), then replace or reverse the cutting edge and the end bit. 2) Install the cutting edge on the blade and tighten the bolt temporarily.
Press the blade against the ground to eliminate the play of bolt (2), then tighten the bolt to the specified torque. Tightening torque of mounting nut: 255 ± 34.3 Nm (26 ± 3.5 kgm , 188.1 ± 25.3 lbft) If bolt (2) and nut (1) are damaged, replace them with new ones at the same time. 6. After several hours of running, retourque the nuts. 4 - 32 It is dangerous if t he wor k equipmen t moves during t he t urning or replacement o Set t he w ork equipment i n a stable c ondition , set the wor k equipment lock lever t o the LOC K position, then stop the engine. Revers e or replace the end bits and cutting edges befor e it is worn out t o the blad e en 1.
Rai se the blade to a proper height, position a b lock u nder the fr ame to preven t the blade from fal ling. 2. Set the work equipment lock lever t o the LOCK position and st op th e engine. 3. Measure the wear of the end bit an d cutting edge in accordanc e with the wea r standards given b Wear st andards Item Judgement standard No. Measurement point Standard dimension (mm (in)) Repair limit (mm (in)) 1 Height of end bit 80 (3.2) 55 (2.2) 2 Height of cutting edge 80 (3.2) 55 (2.2)