Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE 4 - 56 ADJUSTIN 1. Loose n mounti ng bolts ( 5) and lock bolt (6). 2. Open engine s ide cover (7) on the le ft side o f the machin e. 3. Loose n locknu t (8), then tighten adjustment bolt (9) to adjust . ustment (9) djust the be lt tension 4. After adjusting, tighten lo cknut (8), m ounting bolts (5) and lock bolt (6 ). 5. Chec k each pu lley for da mage, wear of the V- groove, and wear of the V-belt. In particula r, be sure to check th at the V-belt i s not touch ing the bo ttom of the V-groove . cannot be adjusted any replace it. a new part, there will be 6. If the more V-belt is or if it ha so lengthened that it s any cuts or cracks, cannot replace 7.

If the V-belt ha s been re place d with a new initial elongatio n, so adj ust the belt a gain aft er operating for 2 to 3 d ays. engine side cover (7) on the left side of the machine. cover (2). 8. Close engine s ide cover (7) on the l eft side of the machin 9. Install cover (2 10. Install front cov